By its parameters, this method in most cases is the best, and sometimes the only choice. When water-jet cutting is applied, the material that being processed is not heated, not deformed, there is no need to make any preparations. The accuracy of cutting is so high that in most cases final treatment is no longer required.

There are virtually no restrictions on the material to be used, with equal success water-jet can also cut glass and copper sheets, which cannot be done with a laser. It is no problem to cut of composite / combined materials in any combination.

When cutting parts from expensive materials - minimum waste of the process will be an important factor as the thickness of water-jet is just 0.1-0.3mm. Added to that, the cutting job is optimized so that waste and scrap were as little as possible.

The main feature being the main advantage of our water-jet is fast and accurate production by cutting various products, where traditional methods are impossible or hard to apply.

For example: Cylinder head gasket for the engine, that is out of production for some time. Water-Jet cutting of the material solves this problem with the absence of spare parts. At the same time - the technological process is reduced to a minimum, there is no need to produce DIE stamp and other tooling, and hence - the costs are minimal.